Can monitor up to 6 regular tanks and 2 LP tanks that already have 90 ohm sending units in them or other resistive sensors like the WEMA fuel float sensors. If your resistive sensor has opposite calibration settings (ie 0-240 ohm where 0 is Full and 240 is Empty) then click here for the modified calibration instructions for those resistors.

**If you are purchasing the iSeries panel to upgrade from the older Ultra 8 panel and would like to keep your Ultra 8 wiring harness (the harness and set-up is the same but the colors of the wires are different), please select the Ultra 8 upgrade option below so we can do a small modification to the power switch to accommodate your old harness. A new wiring harness will not come with this option.

If you would like to add additional switches to the panel (ie. Water Pump, Water Heater or Generator switches), please check the designated boxes further below.

Can monitor up to 8 regular tanks. Check the boxes below to add switches.

Please check the boxes below if you would like these options with your iSeries Tank Monitor:

The MODA sensor module is a non-invasive exterior tank level sensor. This sensor is attached to the outside of a plastic or fiberglass tank eliminating the possibility of sensor malfunction due to fouling by tank contents. (This will not work on a metalic tank. If you have a metalic tank, please order a custom built rod for the interior of your tank listed below.)

Download Exterior Moda Sensor Installation Guide

Cosmetic knicks in the case only, 100% functional and fully warrantied.

(These rods are custom made to length. Please give up to a week for manufacturing time although most of the time we are able to get them out in a few days.)

Please click here to see how to measure for the length of your rod. Rod Lengths have a tolerance of +/- ¼".

1" Pipe Flange 511-605HC - Adapter for PVC sensor rod to install into your tank - please add 1" measurement to your PVC rod order.

View the PVC Rod Sensors PDF

Adapter for the PVC sensor rod to a standard 5 star hole pattern cut out. Please add 1¼" to your rod measurement if you are using this adapter.

View the PVC Rod Sensors PDF

To regulate the input voltage to 10 volts on the older style boards (Smart Mini & 703 Smart 3 Tank). If you are adding this after your system is already set-up, you will need to recalibrate your panel. If you have purchased your system within the last year, please call us at (541) 610-0401 to verify purchase date and there will be no charge for this adapter.

Data Sheet

For tanks with "Ledges" or "Step-Outs". 2 Jumper wires with copper pads soldered onto each end.

Data Sheet

2 Copper sticky squares with 6" wires already soldered to them to splice to your current moda sensor wires and 2 Butt Connectors.

Download Moda Sensor Repair Kit Installation Guide

Download Moda Sensor Repair Kit Installation Guide

Data Sheet

Data Sheet

Data Sheet

Inline Fuse assembly including 2 - .5 Amp (1/2 Amp) fuses. This is already included in all kits and panel only purchases with a single fuse.

Basic digital voltage meter for testing panels and sensors. Measures AC and DC; current and resistance. Click on the picture for a larger view of the product.

Did you lose or damage your iSeries wiring harness?

Replacement iSeries wiring harness.

This modified harness is used if you have multiple panels going to the same sensors or if you are modifying your wiring set-up as you only have 1 wire from each tank back to the panel. Please call tech-support prior to purchasing this harness to see if it will meet your needs. Pricing is $35 per wiring harness to modify them on an existing order, or $45 if you are ordering it by itself.